Azheat
I purchased a couple of these Turnigy on/off switches, from Hobby King and I'am having a difficult time wiring it up for my landing lights, off my 1300 battery pack. I want to be able to use my "Landing Gear" switch on my Spektrum 6i to flick the lights on/off, via the Turnigy Switch. Would anyone like to share any information on how to wire this darn thing? I did get a a wiring diagram with it, but I must be doing something wrong. Thanks for any help that might come my way.
Turnigy.jpg 
Quote 0 0
useless-thumbs
Those drawings are a bit confusing.
I think this is how it should go.
+ from battery to switch
+ from switch to + on lights
- on lights to battery -
That makes a circuit.

Plug in servo type connector from switch to Rx and test.

Hope this helps
Quote 0 0
rodrigo
Please specify wish type of light you have and voltage need it and his many light need.
The first diagram is ok if you need all the battery voltage but if you have a LED kit (with voltage controller ) and works with the same voltage of the receiver just use a Y harness from the selected channel and use one connector for the switch and with the other make a pass through with the red wire in the positive connector of the switch (the voltage side of the switch)...

Enviado desde mi GT-I9100 usando Tapatalk 2
good luck!

tx Futaba 9CAP & 8U
Quote 0 0
useless-thumbs
Quote:
Please specify wish type of light you have and voltage need it and his many light need.
The first diagram is ok if you need all the battery voltage but if you have a LED kit (with voltage controller ) and works with the same voltage of the receiver just use a Y harness from the selected channel and use one connector for the switch and with the other make a pass through with the red wire in the positive connector of the switch (the voltage side of the switch)...

Enviado desde mi GT-I9100 usando Tapatalk 2

I hadn't thought of that - Good point.
Quote 0 0
rodrigo
switch.jpg  this diagram will work with a standard 3 navigation LED kit...
how connect a external BEC to get more power? just use a unused plug in the rx or connect it throught a Y harness to any control channel
good luck!

tx Futaba 9CAP & 8U
Quote 0 0
rodrigo
Quote:
[ATTACH=full]21544[/ATTACH] this diagram will work with a standard 3 navigation LED kit...
how connect a external BEC to get more power? just use a unused plug in the rx or connect it throught a Y harness to any control channel


BTW green line is the yellow or white wire... I have not a yellow pencil here
good luck!

tx Futaba 9CAP & 8U
Quote 0 0