RaptorPilot
The NTM PropDrive 2700 just arrived. Did not realize a prop adapter is not included...my fault. But there doesn't seem to be one offered by HK. Other than fabricating a firewall, anyone know where I can get an adapter?
RP
Quote 0 0
drive and air smash
anywhere just look up the shaft size of the mototr and look for an adapter for that shaft size. Hobbyking sells them any hobby shops that are close to you might even have some. They might be a little pricey but hey they will work and get the job done. Hope this helps.
When life gives you lemons you make grape juice... then everyone stands back and wonders how you did it .

Check out my YouTube Channel!
https://www.youtube.com/channel/UCCdMYt3mq1eoooP7yqg1YJw
Quote 0 0
F1wanabe
Quote:
The NTM PropDrive 2700 just arrived. Did not realize a prop adapter is not included...my fault. But there doesn't seem to be one offered by HK. Other than fabricating a firewall, anyone know where I can get an adapter?
RP

There is a prop adapter offered on the prop drive page. $1.65 I think. You do need it since shaft is not reversible.
Quote 0 0
RaptorPilot
F1 OK searched at "prop drive" no help. Don't have the part number do you?
RP
Quote 0 0
RaptorPilot
F1 Googled it and found an old post by you, part number is NTM28-acc, but it looks like it's not available in the US wharehouse
RP
Quote 0 0
RaptorPilot
drive and air smash
Thanks for trying to help but this set up is different than most. You either have to firewall mount it or get a prop adapter that attaches with three screws, not a collet.
Thanks
RP
Quote 0 0
F1wanabe
Quote:
F1 Googled it and found an old post by you, part number is NTM28-acc, but it looks like it's not available in the US wharehouse
RP

Oh, that may be possible. I can send you the one from my siezed 2700. PM me your address.
Quote 0 0
RaptorPilot
F1 PM sent Thank you sir
RP
Quote 0 0
F1wanabe
Any time. Hope you can use it longer than I did
Quote 0 0