tarzan13
I have a futaba c7 and want to put elevon mixing on my ailerons without them acting as elevators.
without puting on board mixier can it be done cause they only act as elevon when using y cables they do both pitch and roll
thanks for reply
Quote 0 0
tarzan13
found it
p-mix 1 on
master channel 1 slave
both rates 100%
switch --

P-MIX1 ON
MAS> CH1
SLV> CH6
SW> --
RT>100%
>100%


you put you aileron on channel six with a Y cable and your set
Quote 0 0
squishy
You need to read the manual for your futaba c7 (see page 47) and find the section on dual ailerons (called Flaperon on your manual), you can also do this as a mix, just invert the ailerion channel and send it out an aux channel, bust most likely you don't have to do that because most modern radios have the dual aileron setting in the radio.
"Education is not about filling buckets; it is lighting fires." W.B. Yeats

http://www.youtube.com/user/squishy654
Quote 0 0
tarzan13
Quote:
You need to read the manual for your futaba c7 (see page 47) and find the section on dual ailerons (called Flaperon on your manual), you can also do this as a mix, just invert the ailerion channel and send it out an aux channel, bust most likely you don't have to do that because most modern radios have the dual aileron setting in the radio.

Thanks alot for replying used the mix and it work.
Quote 0 0
tarzan13
tried it with flaperon and it alot easier to programe!
thanks squishy
Quote 0 0
fw109e
can someone help me with the mix on a trungy 9x, when set up as per instructions elv mix with al
Quote 0 0
rodrigo
I know squishy put a good answer but try to post more info about what do you try to make... especially the plane type...it's a conventional ailerons and elevator plane or you need a tail working as a elevon ?
if you need a elevon like tail and you have a 7c 2,4ghz, you are lucky... this tx has the function named AILEVATOR with the second elevator connected to channel 5 Or 7...


Enviado desde mi GT-I9100 usando Tapatalk 2
good luck!

tx Futaba 9CAP & 8U
Quote 0 0