Matt476 Show full post »
Matt476
Ok so I'm a little confused this is a receiver and 2 servos. I see the 2 ports for the motor is that all I need? Thanks for all the help guys I'm terrible at picking the correct electronics .
https://gyazo.com/daff5a1b245b405e4196b6f6034be3e3 Also does anyone know how the binding proses works on theses?
Quote 0 0
Wildthing
Quote:
Ok so I'm a little confused this is a receiver and 2 servos. I see the 2 ports for the motor is that all I need? Thanks for all the help guys I'm terrible at picking the correct electronics .
https://gyazo.com/daff5a1b245b405e4196b6f6034be3e3 Also does anyone know how the binding proses works on theses?

From what I can tell from the picture, they are showing you where to solder your two motor wires. The two empty ports well one is labelled for an aileron option and the other is the bind plug, I would assume but don't quote me you would need a plug that basically grounds the terminals together to put the rx into bind mode same as a normal receiver and more then likely the same process. it is a receiver with two linear servos, in the left picture those 2 motors and that part beside it are your servos and you control wire will attach to it.
Quote 1 0
Matt476
ok thanks
Quote 1 0