Sidewayskiwi
Doing final tests for my oversize profile Flanker
Running a Turnigy 3632 1500kv 1045 carbon prop on two 2200 3S batts (firstly for balance secondly for flight time) Simonk 40 amp ESC
Manuf specs 35 amps 10x5 prop for 1.8 kg thrust
Watt meter time Hmmmmmm
68.5 amps and 785 watts 
Motor gets mildly warm ESC got hot (obviously) got an 80 amp to swap in 
No binds (did arrive with a naffed bearing from new --replaced) 
Virtually no info out there on these other than basic specs from hobbyking
Anyone got any ideas
Quote 2 0
Wildthing
Doing final tests for my oversize profile Flanker
Running a Turnigy 3632 1500kv 1045 carbon prop on two 2200 3S batts (firstly for balance secondly for flight time) Simonk 40 amp ESC
Manuf specs 35 amps 10x5 prop for 1.8 kg thrust
Watt meter time Hmmmmmm
68.5 amps and 785 watts 
Motor gets mildly warm ESC got hot (obviously) got an 80 amp to swap in 
No binds (did arrive with a naffed bearing from new --replaced) 
Virtually no info out there on these other than basic specs from hobbyking
Anyone got any ideas


Well even on the small Turnigy 2826 1400kv 10T motor I run a 40A esc, their spec must be wrong. If you are pulling 68A put your 80A esc into it. 
Quote 1 0